50 l/h hanging microsprinkler Plastro

   50 l/h hanging microsprinkler Plastro Rondo are used in greenhouses and solars for fine irrigation with small drops of water, or for humidifying the air.
   Micro-sprinklers are used in greenhouses and solars, gardens, fields, orchards for fine watering. This system distributes water in a rain-like shape, ensuring even distribution over the entire irrigated area as well as overlapping surfaces. Provides increased humidity and cooling (in greenhouses and solars) and adaptation to germination and rooting (carrot, parsley, onion, lettuce, etc.).
   Rondo micro-sprinklers (minisprinclers) have a very wide variability, with different rotors and nozzles with a capacity from 40 to 300 l/h, with a watering diameter between 6.5 - 10.7 m.
   The minimum operating pressure is low (0.5 - 1 Atm.) and the ideal pressure is between 1.5 - 3.5 Atm. It has a flow rate of 100 liters of water per hour.
   The assembly scheme of the micro-sprinklers is 2 in 2 meters. For solars wider than 6 meters, 2 sprinkler lines are recommended and for solars with 10 meters lenght are recommended 3 sprinkler lines. The pipe used for the spray lines is soft polyethylene (PELD blind tube) of 20 or 25 mm. The pipes diameter depends on the number of sprinklers and their flow. The soft polyethylene with 20 mm can carry a flow of about 500 l/h and the 25 mm a maximum flow of 1000 l/h, soft polyethylene with 16 mm is not recommended for sprinkler lines, because it is too small at the intersection. If the length of the sprinkler lines exceeds 50 meters is recommended to divide the lines in two (fed from the middle) for the best possible watering/cooling uniformity. The thoroughfare from which the sprinkler lines start is calculated according to the total consumption of the sprinklers. The anti-drip is a very important part in the case of plants (tomatoes, cucumbers) that can not stand if large drops of water reach the surface of the leaves (this is an advantage of the anti-drip). And a disadvantage is that the dripper opens at a certain pressure, with 1, 2 or 4 bar. The anti-drip is compatible with Plastro microsprinklers and even with some models of Netafim sprayers.